An operator can load a guide wire, angioplasty
wire, vascular closure wire, biopsy tubes, aspiration tubes
or any types of small wires or tubes to be plasma welded
on the end of the part. The plasma welding system sequence
is controlled by a PLC and a DT-100 programmable weld controller
that controls the weld parameters such as time, pulsing,
slopes, preflow and postflow gases, etc.
Wire or tube stick out from the tooling can be set with a
micrometer adjustment. X/Y/Z torch slides adjust the position
of the plasma welding torch for proper welding alignment.
Part clamping, movement to weld position and retract to unload
the part are pneumatically controlled. Dual palm buttons
for weld start sequence make the system safe for the operator.
Tooling can be provided for different sizes of wire and tubes.
Weld training can be provided with a system. |
